This page outlines general use of the Engage Inferno.
🔊 Connect to your speaker
Connect the aux output port to your selected speaker via the included aux cable.
▶️ Powering On
Using the supplied cable connect the micro usb port on the main pcb board to your powerbank.
The unit will auto power on and boot sound will be played to confirm the unit is ready (if it is already connected to an active speaker).
🔌 Power for the Fans
The fans rely on the 9v battery supply. There is an On/Off switch on the battery bank.
Don’t forget to switch this to On before use.
🔘 Onboard button test
WIth everything connected and the unit powered on you can use the onboard button to test the unit and confirm everything is working as expected.
📡 RF Remote
The RF remote is already ‘binded’ to the reciever. Once connected pressing the button on the fob will activate the system.
Was this article helpful?
Your feedback helps us improve these guides.